JoyDS supports up to 16 DS connected to one PC. Press Save to save the sequence or X to cancel. The Interval is a number from 0.1 to 10 seconds. To add a Press and a Release you just need to press and release the respective button on the DS, and to add a Interval just choose it on the little box (Seconds) and press the Interval button. An item of sequence has 3 possible actions: Press a button, Release a button and Wait. Inside the server, click on the button to set a combo, this will enable the Combo Panel.
Go to Customizing section to see some ways to make your emulation even better like Combos and Multiple Consoles. Press any buttons on the DS and see if the Server shows the buttons being pressed (test the Stylus Analog too). Set the IP and Port that DS will use (See above). JoyDS turns off the light on both screens after some time, but user can still access the Settings screen from the Blue Star. To choose what IP and Port to send data to, hold down the Stylus at the Blue Star (bottom right corner) for a few seconds. Here can view what IP and Port that is sending data to and use the Stylus Analog (See Customizing for more information). After connecting, it shows the main screen. To use WEP protection, set the access point with protection inside WFC settings of an original game then connect with JoyDS using the first item of the list: WFC Config (can use WFC Config without protection too).Īfter selecting the AP (or WFC Config), touch Ok or press A to connect. JoyDS will search for any Access Points in range and list them, gray ones have WEP protection. The Main window shows the Virtual Joystick buttons and analogs, where you are able to set some options (See Customizing for more information). You can select a language, English or Portuguese BR. This is useful if you want to use two or more consoles at the same time, so each one uses a different port. If Windows shows New Hardware Found windows, make it Install Automatically, if it couldn't find any drivers, point to PPJoy Folder.Ĭhoose the port (UDP) where DS will send data to. If it isn't installed, JoyDS will create it. In the first window you can select what Virtual Joystick you want. If an error occurs asking for PPJoyBus.sys, read this.Ĭopy JoyDS.nds (or JoyDS.ds.gba) to the flash card. Go to Control Panel> Parallel Port Joysticks. JoyDS is an application that able to use NDS as a joypad using PPJoy, no configuration is needed as installing it and run JoyDS Server, it creates, manages and deletes Virtual Joysticks automatically.
0 kommentar(er)
